At-Home Wax

NOT INTENDED FOR USE ON THE EYE AREA.
VIEW FULL DIRECTIONS IN THEIR ENTIRETY BEFORE BEGINNING.
1. Place the cup in a microwave oven and heat in 30-second intervals, until the wax is the consistency of thick honey. A full cup usually takes up to five to six 30-second intervals to melt the wax to the desired consistency. Actual heat times may vary depending on your microwave and the amount of wax in the cup. If wax is too thin, allow to cool and thicken in the microwave before removing.
NOTE: To ensure even heating and optimal performance of wax, stir semi-melted wax between each 30-second microwave interval.
If the wax gets too cool during waxing, simply re-heat cup for 30-second intervals until ready. If wax is too thin, allow to cool and thicken in the microwave before removing.
The cup may be warm to the touch so always remove from the microwave by using the handle. HOT WAX CAN BURN.
DO NOT heat cup on the stovetop, in a conventional oven, or any other manner besides as instructed.
2. Before you begin, use a spatula to test the wax temperature on the inside of your wrist. Wax should be spreading consistency but not be uncomfortably hot.
3. Cleanse the area to be waxed with lukewarm water or a damp towel and blot dry. Then massage a few drops of Pre- & Post-Waxing Oil onto the skin. Blot away any excess oil, as it may keep the wax from gripping.
4. Dip a spatula in the wax, and twirl to avoid dripping.
5. Apply the wax AGAINST the direction of hair growth for short hair (bikini, lip, chin and cheeks), or WITH the direction of growth for longer hair (legs, arms and underarms).
BLISS TIP: When you apply the wax, layers should be as thick as a banana peel (about 1/8”). Make sure to use some pressure when applying the wax, to form firm and full edges for easy peeling.
6. When the wax has dried enough so it is not tacky to the touch, it is time to remove (but don’t wait too long – wax may crack). Press down on the entire patch to ensure a uniform removal, then hold the skin tight, grab an end, and remove the wax in a brisk fashion against the direction of hair growth.
BLISS TIP: After removing the wax, apply immediate pressure to the waxed area to dull any discomfort.
7. If you need to wax the same area more than once, reapply Pre- & Post- Waxing Oil as necessary.
8. Once you have finished, cleanse the area with lukewarm water or a damp towel to help prevent ingrown hairs, and follow with Pre- & Post- Waxing Oil to soothe skin and remove any residue.
BLISS TIP: To further prevent ingrown hairs and bumps, we recommend a swipe of Bliss’ Ingrown & Razor Bump Solution the day after your waxing session.